Gizmo

The FlowMeter PRO Revision 3.6 is a flow measuring turbine that can be attached directly to your mother board! It will measure the flow of in your watercooling system and indicate the flow value in revolutions per minute so that it can be read directly by your motherboard's BIOS.

The integrated blue LED also allows a visual indication of the flow as it flashes with the turbine revolutions - plus it is a cool optical effect! Designed for an extreme life span and quite operation, this flow meter will probably outlive your system! Designed for 8mm I.D. / 10mm O.D. Tubing.

Detail:

By connecting the FlowMeter PRO directly to your motherboard, you can check your system's flow rate via BIOS monitoring software. The BIOS reads the signal as if it was a tachosingal from a standard CPU fan. The linear signal indicates the flow of liters per minute. 2800 pulses equals 1 liter per minute, so 0.7 liters (ideal flow for an innovatek system) would be seen in the BIOS as 1960 RPM.

Features:Connects directly to your computer's motherboardPulse rate is 2800 pulses per literSpecially designed measuring chamberUses 3-pin fan connector55 cm cableCompact design: 79 (L) x 41 (W) x 21 (H) mm (Including fittings)Designed for 8mm ID / 10mm OD tubingCompression Fittings (Non-exchangeable)Blue LED flashes for each revolution - will appear constant during normal flow

Includes:FlowMeter PRO Rev. 3.6LED with 3-pin Fan header connectorCompression fittings for 8mm ID / 10mm OD tubing

Warning: Use of fluids other than the Innovatek Protect family is not recommended. Innovatek will not RMA defective products that have used alternative fluids, including UV Dyes. Do not use alcohol based cleaners on innovatek products.

Did you know?
The innovatek Protect Products are the only licensed corrosion protection fluids in the PC-field that are officially approved by EHEIM for their pumps. Why take risks? Be save and trust the specialists!http://www.frozencpu.com/ex-flo-03.html?id=XSADauVY