Introduction:

The H20-80™ revision 3 liquid cooling kits take the award winning H20-80 Rev2 series one step further, with the introduction of the revolutionary MCP350™ pump. This pump redefines performance, whisper-quiet operations, and extreme reliability in a size no bigger than a pack of cigarettes. All other components being identical to the Rev2 series, the H20-80 Rev 3 perform equally well but are easier to install.

The H20-80 Rev3 series cooling kits are perfect for installation in Mini or Micro ATX chassis due to the small size of the various components.

These kits are specifically intended to bring the efficiency, and quiet operations of liquid cooling to confined environments. They require no case modifications, and may be installed with all existing components already in place inside the chassis (*)

Performance features:Extreme performance MCW6000™ series water-blocksExtreme performance MCP350™ 12 Volts DC industrial pump1/2" OD tubing for optimum flow rate, and reasonable bulkGood balance for performance versus noise is achieved with a single MCR80-F2 80mm copper fins radiator featuring an 80x25mm fan optimized for low noise (28dBA) and high back pressure.Extreme performance can be achieved by adding a second MCR80-F2 for a gain of up approximately 4°C.

Convenience & reliability features:12 Volt DC pump plugs directly into computer power supplyHigh-reliability, no-maintenance MCP350 industrial pump features whisper-quiet operations thanks to brushless motor, and is rated at 50,000 hour MTBF(Mean Time Between Failures) equivalent to 5 year lifetimeSmall size pump fits anywhere into the computerMCRES-525™ 5 1/4" Drive bay reservoir allows a quick and easy procedure for filling-up the system80mm form factor radiator fits into any chassis featuring at least one 80mm opening for fan intake or exhaustPre-installed tubing on the waterblock and pump, and quick-connect fittings on the radiator reduce installation time.Plug-and-play waterblock installation, doesn't require removing the motherboard (most models)Coolsleeves™ coils completely eliminate flattening of the tubes over time, and enable users to bend soft vinyl tubing at extremely sharp radii without kinking.

Optional devices and configurations:Add a VGA cooler such as the MCW50™Add a chipset cooler such as the MCW20™Add a second water block for multiprocessor applications, such as dual AMD®, dual Xeon™, or dual Opteron™.Add a second radiator for a performance gain of up to 4°C at equal heat load. Note: this option is always recommended in dual processor configurations

Part # H20-80-S™ for Intel® Pentium® 4 (socket LGA775) & AMD® Socket A (Duron, Athlon XP) processors includes:MCW6000 "Step base" water block, with pre-installed tubingIntel® Pentium® 4, socket LGA775 hold-down plate and retention hardwareAMD® socket A (Duron, Athlon XP, MP) hold-down plate and retention hardwareMCR80-F2 Radiator with (1) 80x80x25mm fans rated at 31.4 CFM and 28dBA, color coded-quick-connect fittings & fan guardMCP350™ 12 Volts DC industrial pump (connects directly to computer power supply ), with pre-installed tubingMSRES-525™ 5/14" Drive bay reservoir & fittings4 feet 1/2" vinyl tubing, and tube inserts2 Oz bottle HydrX™ extreme duty coolantCéramique™ thermal compoundCoolsleeves™ Clear 40" length

http://www.frozencpu.com/cgi-bin/fro...ml?id=3WHrnhor