Introduction:

The H20-120™ revision 3 liquid cooling kits take the award winning H20-120 Rev2 series one step further, with the introduction of the revolutionary MCP350™ pump. This pump redefines performance, whisper-quiet operations, and extreme reliability in a size no bigger than a pack of cigarettes. All other components being identical to the Rev2 series, the H20-120 Rev 3 perform equally well but are quieter, and easier to install.

The H20-120 Rev3 series cooling kits are configured for performance oriented users and overclockers who wish to maintain a quiet working/playing environment.

Performance features:High thermal dissipation is achieved with a single MCR120-FB 120 mm copper fins radiator featuring a 120x25mm fan selected for low to moderate noise (34dBA) and high back pressure.Extreme performance at reasonable noise can also be achieved by adding a second MCR120-FB for a gain of up to 3°C.Extreme performance MCW6000™ series water-blocksExtreme performance MCP350™ 12 Volts DC industrial pump1/2" OD tubing for optimum flow rate, and reasonable bulk
Convenience & reliability features:12 Volt DC pump plugs directly into computer power supplyHigh-reliability, no-maintenance MCP350 industrial pump features whisper-quiet operations thanks to brushless motor, and is rated at 50,000 hour MTBF(Mean Time Between Failures) equivalent to 5 year lifetimeSmall size pump fits anywhere into the computerMCRES-525™ 5 1/4" Drive bay reservoir allows a quick and easy procedure for filling-up the system120mm slim form factor radiator fits into most chassis equipped with at least one 120mm opening for fan intake or exhaust, and can optionally be installed externally to the back of any chassis featuring at least one 60, 80 or 92mm exhaust fan, by using our patent pending MCB120 "Radbox"Pre-installed tubing on the waterblock and pump, and quick-connect fittings on the radiator reduce installation time.Plug-and-play waterblock installation, doesn't require removing the motherboard (most models)
Coolsleeves™ coils completely eliminate flattening of the tubes over time, and enable users to bend soft vinyl tubing at extremely sharp radii without kinking.

Optional devices and configurations:Add a VGA cooler such as the MCW50™Add a chipset cooler such as the MCW20™Add a second water block for multiprocessor applications, such as dual AMD®, dual Xeon™, or dual Opteron™.Add a second MCR120-FB radiator for a performance gain of 3°C average at equal heat load. Note: this option is always recommended in dual processor configurations

Part # H20-120-D™ for Intel® Xeon™ (all versions) & AMD® Opteron™ dual processors(2) each MCW6000 "Flat base" water-blocks, with pre-installed tubing(2) each Intel® Xeon™ (all versions) holding plates and retention hardware(2) each AMD® Opteron™ holding plates and retention hardware(1) MCR120-F Radiator with (1) 120x25mm fans rated at 72.4CFM and 34dBA, and (2) 1/2" (tube OD) quick-connect adapters.(1) MCB-120 "Radbox"MCP350™ 12 Volts DC industrial pump, with pre-installed tubingMCRES-525™ 5 1/4" drive bay reservoir & fittings4 feet 1/2" vinyl tubing, and tube inserts2 Oz bottle HydrX™ extreme duty coolantCéramique™ thermal compoundCoolsleeves™ Clear 40" lengthAJ00172 backing plate and retention frame

Reviews:

http://www.frozencpu.com/cgi-bin/fro...ml?id=3WHrnhor