The 305 in my Camaro spun all It's bearings hardcore and I really need to the money to cover the labor it will cost to put in the new 350 setup. I have a bunch of parts that are all brand new and never used that have just been sitting in the corner for months. The first pieces for sale here are some server bits.

I have for sale a rackmount case/motherboard combo.

The case is a generic 3U rackmount case designed for extended ATX. It has installed into it a SuperMicro H8DCE Dual Opteron motherboard which is revision 3.1, which is the problem free revision. This board is NUMA conpatible. There were some modifications done to the case. The middle crossbar with the 4 fans on it I took the wire to the fans, routed them hidden between the fan frame and the crossbar soldered all the fan tails together on one molex connecter and covered the joints with hotglue to help tidy up the wiring. I also cut a window into the case and did a custom etch on the window. This was to be used as a gaming server for my clan but unfortunately it never got that far. All connections from the case for USB and front panel are already hooked up to the board. It will come with 8 SATA cables and the driver disc as well as the accessories for the rackmount case. The window can be switched out for a plain one if desired by purchasing a new one at FroZenCPU but I will warn you I cut this thing for a snug fit and the molding around the window is VERY difficult to get back into place once removed. Outside of the case is a bit dusty but the inside is clean as a whistle. Window has fingerprints on it and could use some cleaning.

Asking $300 + shipping for the two.

I am here.

And my ISP E-Mail is FireDemonSiC(at)verizon(dot)net



Thanks Lokie.

Attached Thumbnails

     

     

     

 

FD, I need you to post in this thread under your new handle "FireDemon". Note there is no sufix 666 or sic.