| |||||||
| Project Worklogs This is the place to start your ongoing mod project threads. |
![]() |
| | LinkBack (69) | Thread Tools | Display Modes |
| |
#261 (permalink)
| |
| True, good point. Cutting might not be necessary though...separate pieces of steel could be cut to form mounting plates, only a few drill holes would be needed in the powdercoated rear part. However, I noticed another obstacle to this: that humongous PSU needs every bit of support it can get, and the only support to be found is that inch-wide shelf or lip. | ||
| | | |
| | #263 (permalink) | |
| I want say I am Sorry to all the Members Here :cry: for the lack of posts and updating my Worklog. This thing called HWbot has been taking up all my time "ITS LIKE CRACK" But my hard work has paid off I am Ranked 9th in the World HWbot.org - Member Hall Of Fame. I will be updating this worklog this week GO SPINNER!!!!! | ||
| | | |
![]() |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The Register // IT is a cost not a money-spinner, biz says | Gizmo | The Register RSS | 0 | 03-August-06 05:59 PM |
| Case for project | Cis | Case Modding | 10 | 09-September-05 11:47 PM |
| First Mod Project: F-117 case. | vf1000ride | Project Worklogs | 11 | 08-March-05 11:19 PM |
| FrozenCPU // 80mm Spinner "Grillter" Laser Cut Fan Grill w/ Filter (FG800-10) | Gizmo | Vendor News RSS | 0 | 15-January-05 11:48 PM |
| Airplane spinner?!?!?! | benjaminrhs666 | Case Modding | 13 | 11-December-03 06:56 AM |