Affiliate Article: Star Wars engraved Lian Li

FunkyFresh · 02-August-05, 10:56 AM

Case engraving: Star Wars

Quote:

Originally Posted by bit-tech.net


	Unfortunately, I had to tone down the detail a little when doing the engraving, since the design looked a little too 'busy'. However, with that done, the left side needed something more - another Star Wars logo did the trick. This made Yoda appear more clear and helped to get the right balance in the design. Full Story at bit-tech.net

IMO, the finished product looks much better than this thumbnail they provided.

TYCOON · 02-August-05, 11:54 AM

The darth vader looks out of place.

The rest look awesome!

Bionic · 02-August-05, 12:35 PM

I agree with FF... the farther away you get, the better it looks

I'm impressed at the guts it takes to dremel up a Lian-Li, though. I screwed up my plexi etch at least 3 times, and then I could always just toss it and get a new piece.

tstalzer · 03-August-05, 12:46 PM

justt checking to see how this works

03-August-05, 12:46 PM		#4 (permalink)
tstalzer Banned	Test justt checking to see how this works

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Affiliate Article: Blog Wars - Views from the Front Line	Twizted	PC Apex Web News	0	05-October-06 11:47 AM
Affiliate Article: Extreme Lian Li cooling mod at bit-tech.net	Twizted	PC Apex Web News	0	09-July-06 02:35 PM
Affiliate Reveiw: Star Wars: Knights of the Old Republic Review	Lokie	PC Apex Web News	1	20-February-04 08:28 PM

02-August-05, 11:54 AM		#2 (permalink)
TYCOON Apex Tech God	The darth vader looks out of place. The rest look awesome!

02-August-05, 12:35 PM		#3 (permalink)
Bionic Apex Tech Maniac	I agree with FF... the farther away you get, the better it looks I'm impressed at the guts it takes to dremel up a Lian-Li, though. I screwed up my plexi etch at least 3 times, and then I could always just toss it and get a new piece.