How about not sanding?

spazticbusdriver · 19-May-04, 02:10 AM

Has anyone used kyrlon fusion paint be4 on cases made of ABS plastic? I use it all the time to paint PVC but never on ABS. For those of you who dont know what krylon fusion paint is...it is a paint ment for plastics. It drys in about 15 mins, comes in gloss and satin, no sanding needed. Its possiably the best type of paint for plastic if you are on a budget. But I just havent tryed it on ABS.....

Badaziam · 19-May-04, 07:23 AM

I've used it several times on ABS and I was pleased with the results. They werent as good as lacquer paint and wet sanding but were still better than average.

19-May-04, 02:10 AM		#1 (permalink)
spazticbusdriver Apex Advanced Techie	How about not sanding? Has anyone used kyrlon fusion paint be4 on cases made of ABS plastic? I use it all the time to paint PVC but never on ABS. For those of you who dont know what krylon fusion paint is...it is a paint ment for plastics. It drys in about 15 mins, comes in gloss and satin, no sanding needed. Its possiably the best type of paint for plastic if you are on a budget. But I just havent tryed it on ABS.....

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sanding down my nintendo	silvafish	Painting	1	01-August-06 05:57 PM
Sanding...	Ben036	Painting	13	06-June-06 12:40 AM
Wet/dry sanding paper	Cis	Anything Goes	8	28-October-04 10:57 PM
Wet Sanding	Spc. Forces Bob	Painting	0	27-April-03 11:17 PM
wet sanding	matrixboy	Painting	5	15-September-02 01:43 PM

19-May-04, 07:23 AM		#2 (permalink)
Badaziam Apex Master Tech Apprentice	I've used it several times on ABS and I was pleased with the results. They werent as good as lacquer paint and wet sanding but were still better than average.