Golden Skeleton Hand

DavidVaini · 05-October-07, 12:29 AM

Hey guys, Ive been working on a case modd and I got an idea for my up and comming "Project Golden Necromancer". You know how many cases have that annoying support bar to hold up the powersupply; well Im going to cut it off and replace it with this Skeleton hand I found that was originally a Halloween Cup. So here is my progress so far:

The Cup

The red plastic cup part was hot glued to the hand so after some brainstorming I decided to stick the whole cup in boiling water to raise the heat enough to losen the glue but not damage the hand. After some twisting and pulling I got the cup part off:

The Hand

The Paint and Result

I think It will go good with my black and gold theme

The Alteration

As you can see I had to alter the thumb because it was positioned too far to the left.. I cut and sanded the thumb down and repositioned it and then super glued it

The Money Shot

Bling Bling!

Wafflesomd · 05-October-07, 12:34 AM

Where did you get that.

I seriously want one.

DavidVaini · 05-October-07, 12:39 AM

Quote:

Originally Posted by Wafflesomd


	Where did you get that. I seriously want one.

This little store... I beleive its named shopko..

Side note: Im a little worried that the hand will be to wide and wont fit inside the case with the window closed... I can always turn the hand or modify it; I just hope I wont have too.

DavidVaini · 12-October-07, 05:43 PM

So I decided to get the antec p180B case instead so im not sure how im going to incorperate this hand. Any ideas?

05-October-07, 12:29 AM		#1 (permalink)
DavidVaini The Green Gator	Golden Skeleton Hand Hey guys, Ive been working on a case modd and I got an idea for my up and comming "Project Golden Necromancer". You know how many cases have that annoying support bar to hold up the powersupply; well Im going to cut it off and replace it with this Skeleton hand I found that was originally a Halloween Cup. So here is my progress so far: The Cup The red plastic cup part was hot glued to the hand so after some brainstorming I decided to stick the whole cup in boiling water to raise the heat enough to losen the glue but not damage the hand. After some twisting and pulling I got the cup part off: The Hand The Paint and Result I think It will go good with my black and gold theme The Alteration As you can see I had to alter the thumb because it was positioned too far to the left.. I cut and sanded the thumb down and repositioned it and then super glued it The Money Shot Bling Bling! Last edited by DavidVaini; 05-October-07 at 09:05 AM..

05-October-07, 12:34 AM		#2 (permalink)
Wafflesomd Banned	Re: Golden Skeleton Hand Where did you get that. I seriously want one.

12-October-07, 05:43 PM		#4 (permalink)
DavidVaini The Green Gator	Re: Golden Skeleton Hand So I decided to get the antec p180B case instead so im not sure how im going to incorperate this hand. Any ideas?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Bluesnews // The Golden Horde Announced	Gizmo	Blue's News RSS	0	08-May-07 10:10 AM
Some amazing hand paintings transfer to a hand..	ranger1033	Anything Goes	5	12-February-07 06:49 PM
Slashdot // Google's Ten Golden Rules	Gizmo	Slashdot RSS	0	06-December-05 05:18 PM
Slashdot // New Golden Age for Outside-the-Box Startups?	Gizmo	Slashdot RSS	0	27-October-05 05:05 PM
Geil Golden Dragon FS	Vertical_Zer0	Trading Post	6	13-April-05 05:48 PM