i have a ps2/xbox component av cable, but since i dont have a xbox, i wanted to mod the plug into a gamecube one (my gamecube is one of the originals, so im pretty sure it has the component ability.) i have 2 of the gamecube composite cords. so does anyone know the pin config for a gamecube component?or maybe a picture that tells whats what on both of the plugs? thanks!

Nintendo Gamecube
Nintendo are up to their old tricks again. The PAL console outputs RGB but not s-video and the NTSC model outputs s-video but not RGB. Therefore this cable will only work on a PAL Gamecube. However, it is possible to get RGB from an NTSC Gamecube by modifying the official component video cable. Here are some guides to the procedure:

GO HERE FOR MORE INFO>>>

Gamecube RGB Mod

S-Video out on gamecube

SNES/N64/GameCube MultiAV connector

Nintendo GameCube Digital AV Connector

Gamecube RGB Mod #2

The CMPV-DOL Chip

This is the chip used in the official Nintendo component cables. It’s made by Macronix, but is only made for Nintendo and Macronix won’t divulge its secrets. The image below shows a cable with the RGB mod applied, hence the RGB select wire on pin 12, and the H/V Sync on pins 21 + 22.






HOPE THAT HELPS YOU OUT.
CUBANCONNECTIONZ
CUBAN