Is there a reputable Bayres out there?

KayinStorm · 26-July-03, 12:54 PM

I've just ordered a 1/2" fitting block and radiator, and I've tracked down the pump I want. Since this is for a top secret project, I can't say much, but I'm wondering is there a bay mounted reservoir that anybody out ther will vouch for? I have a special purpose in wanting it there, and if not, I can make a reservoir out of PVC, but I'd much rather do it this way.

AntiM · 26-July-03, 01:37 PM

I haven't read of any problems with the bay res's outside of barbs leaking. And I'd have to attribute that to user error. I.E. no teflon tape or overtightening. I like the new design Danger Den is stocking. http://www.dangerden.com/mall/Misc_Hardware/tubing.asp
The center section should make it a better air trap than the previous model. And the extra fittings could come in handy.

Rokk1972 · 26-July-03, 01:51 PM

I agree with AntiM, I am using a DD bay res (older version) and haven't had any probs with it. But there is the newer bay res out there with a couple of improvements to the design (but it costs a little more)

jhoop2002 · 26-July-03, 01:57 PM

and the bay res doesn't have the problems the cylinder res has, so you should just fine.

KayinStorm · 26-July-03, 02:48 PM

Sweet. You guys rock. That's exactly what I needed to know.

26-July-03, 12:54 PM		#1 (permalink)
KayinStorm Apex Tech God	Is there a reputable Bayres out there? I've just ordered a 1/2" fitting block and radiator, and I've tracked down the pump I want. Since this is for a top secret project, I can't say much, but I'm wondering is there a bay mounted reservoir that anybody out ther will vouch for? I have a special purpose in wanting it there, and if not, I can make a reservoir out of PVC, but I'd much rather do it this way.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
FS: 5 1/4" DD Bayres	Kage	Trading Post	5	12-June-04 06:00 PM
Bayres &(*#&%#&$&^#	Lord_nikon	Extreme Cooling	7	12-May-04 01:50 PM

26-July-03, 01:37 PM		#2 (permalink)
AntiM Aqua Pimp	I haven't read of any problems with the bay res's outside of barbs leaking. And I'd have to attribute that to user error. I.E. no teflon tape or overtightening. I like the new design Danger Den is stocking. http://www.dangerden.com/mall/Misc_Hardware/tubing.asp The center section should make it a better air trap than the previous model. And the extra fittings could come in handy.

26-July-03, 01:51 PM		#3 (permalink)
Rokk1972 Apex Advanced Techie	I agree with AntiM, I am using a DD bay res (older version) and haven't had any probs with it. But there is the newer bay res out there with a couple of improvements to the design (but it costs a little more)

26-July-03, 01:57 PM		#4 (permalink)
jhoop2002 Apex Tech Maniac Supreme	and the bay res doesn't have the problems the cylinder res has, so you should just fine.

26-July-03, 02:48 PM		#5 (permalink)
KayinStorm Apex Tech God	Sweet. You guys rock. That's exactly what I needed to know.