My plans for my case....

Aciddrag0n · 18-September-03, 09:20 PM

Ok, I've planned out what i'm gonna do to my case so I want you guys to tell me what you think. Its an ATX-mini case (you can look at my pervious post to see a link to it). I plan to paint the entire outside of the case glossy black, and all the inside glossy blue. Then I want to dremel side flames on both sides of the case and put plexiglass behind it. I want to cut the top right above the CD ROM and put plexiglass there so you will be able to see down into the CD ROM. What do you think?

I also want to put blue LED's at the bottom of the case to shine up, but i'm not sure where to draw the power from, does it matter?

Ben · 18-September-03, 09:53 PM

Sounds cool!

Can't say what connector you use matter for LEDs, but if you are using bare leds like ones from ratshack or other you will need a resistor to lower the voltage-as for which one Im not the person to answer that.

gorked · 18-September-03, 09:58 PM

yeah sounds pimp. good luck to ya.

and about the led's, why dont you just use a 6 or 4 inch ccfl?

18-September-03, 09:20 PM		#1 (permalink)
Aciddrag0n Apex Techie Wannabe	My plans for my case.... Ok, I've planned out what i'm gonna do to my case so I want you guys to tell me what you think. Its an ATX-mini case (you can look at my pervious post to see a link to it). I plan to paint the entire outside of the case glossy black, and all the inside glossy blue. Then I want to dremel side flames on both sides of the case and put plexiglass behind it. I want to cut the top right above the CD ROM and put plexiglass there so you will be able to see down into the CD ROM. What do you think? I also want to put blue LED's at the bottom of the case to shine up, but i'm not sure where to draw the power from, does it matter?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
D'sarian Knight Case Mod Plans - Request Feedback	Duane2184	Project Worklogs	6	20-June-07 01:16 AM
silly questions about plans for handbuilt case	not so moving target	Case Modding	14	18-June-07 03:27 PM
Case Mod plans	AznRockthis	Case Modding	1	12-March-05 01:11 PM
major case mod: Turning a mid tower ATX case into a Server ATX case ie adding a secon	Nerdz	Case Modding	12	07-December-03 09:18 PM
Help me find plans for a case	samson12345	Case Modding	1	30-April-03 12:49 PM

18-September-03, 09:53 PM		#2 (permalink)
Ben Mote-Hoe-Cross	Sounds cool! Can't say what connector you use matter for LEDs, but if you are using bare leds like ones from ratshack or other you will need a resistor to lower the voltage-as for which one Im not the person to answer that.

18-September-03, 09:58 PM		#3 (permalink)
gorked Apex Tech Demi-God	yeah sounds pimp. good luck to ya. and about the led's, why dont you just use a 6 or 4 inch ccfl?