Coelecanth ...

godling · 29-May-08, 08:55 AM

Hey man ... was this your post over at NCIX forums?

"Default memory voltage on that board is 1.8, so set your RAM voltage to +.4 volts in the BIOS. That way you'll be sure you won't be overvolting the RAM. Then, remove one stick and run memtest on the remaining stick. If that passes, switch sticks and run memtest again. This will at least tell you if you have a bad stick of RAM."

If so, someone (I can't apparently) need to +rep you. I've got a new build going on, and couldn't the stock ram voltage for that mobo easily (didn't show up in the manual).

-godling

Slaymate · 29-May-08, 05:58 PM

I got him for you :-) Though I haven't seen him in a while :-)

29-May-08, 08:55 AM		#1 (permalink)
godling Apex Tech Maniac Supreme	Coelecanth ... Hey man ... was this your post over at NCIX forums? "Default memory voltage on that board is 1.8, so set your RAM voltage to +.4 volts in the BIOS. That way you'll be sure you won't be overvolting the RAM. Then, remove one stick and run memtest on the remaining stick. If that passes, switch sticks and run memtest again. This will at least tell you if you have a bad stick of RAM." If so, someone (I can't apparently) need to +rep you. I've got a new build going on, and couldn't the stock ram voltage for that mobo easily (didn't show up in the manual). -godling

29-May-08, 05:58 PM		#2 (permalink)
Slaymate PCApex Reviewer From Hell	Re: Coelecanth ... I got him for you :-) Though I haven't seen him in a while :-)

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode